1
Datorn bootar inte(nybygge)
Postat av Acatosh den 11 November 2012, 12:44
7 kommentarer · 340 träffar
Hej!
jag skrev detta på MSI:s forum och orkar inte översätta det till svenska så jag hoppas att det går bra på engelska
I just bought a new computer with the setup:
Intel i5 3570k
MSI GTX 660 ti Power Edition OC
Corsair Vengeance 1600MHz 2x4Gb
MSI Z77A G45
Fractal design Integra 650W
And the thing is that when I start the computer, it doesn't boot. On the screen it only shows "-" in the upper left corner and in the lower right corner it says "A2" and it then changes to say "B2". Then after 2 minutes that screen dissapears. After that a "-" starts flashing continually in the left section of the screen and nothing more happens.
But I tried with no harddrives in and only the OS boot cd and then it went through the same process but it did get into the installation of W7 but since there were no HDD:s in I couldn't install it.(Still skipping the boot phase)
I also tried with a HDD that had w7 installed but since that was configured for another setup it went through the same process but bluescreened immediately when the windows logo showed up.
I've tried to start with only one RAM and switch the RAM slots but still no progress.
I've tried to reset the CMOS too.
Checked all the cables.
POST doesn't show up either.
What might the problem be?
Tack på förhand
jag skrev detta på MSI:s forum och orkar inte översätta det till svenska så jag hoppas att det går bra på engelska
I just bought a new computer with the setup:
Intel i5 3570k
MSI GTX 660 ti Power Edition OC
Corsair Vengeance 1600MHz 2x4Gb
MSI Z77A G45
Fractal design Integra 650W
And the thing is that when I start the computer, it doesn't boot. On the screen it only shows "-" in the upper left corner and in the lower right corner it says "A2" and it then changes to say "B2". Then after 2 minutes that screen dissapears. After that a "-" starts flashing continually in the left section of the screen and nothing more happens.
But I tried with no harddrives in and only the OS boot cd and then it went through the same process but it did get into the installation of W7 but since there were no HDD:s in I couldn't install it.(Still skipping the boot phase)
I also tried with a HDD that had w7 installed but since that was configured for another setup it went through the same process but bluescreened immediately when the windows logo showed up.
I've tried to start with only one RAM and switch the RAM slots but still no progress.
I've tried to reset the CMOS too.
Checked all the cables.
POST doesn't show up either.
What might the problem be?
Tack på förhand






