Hi Fragbite!

From a few years experience with playing online with people i've noticed that alot have problems with Ventrilo, with either sounding to high, or being really quiet...


You had/have the same problem? Well here you have the solution.


Vent Normalization makes everybodies voice the exact same volume. In essence, you won't blow your ear's out or have difficulty hearing people.


*EDIT*

Om tillräckligt många har problem med att förstå vad jag har skrivit så kan jag översätta till Svenska, det är dock lättare med engelska termer då Ventrilo trots allt är ett engelskt program.

Detta är en copy ifrån en tråd jag skrev på mitt Aoc Guild forum.


Detta fungerar till Ventrilo 3.0

____________________



Here's how:


- Go to Setup


- Enable Direct Sound


- Select the SFX Button


- Select Compressor and click Add.


- Under Compressor Properties use the following settings


- Gain = Adjust for how loud you want people to be. (I use 15)


- Attack = 0.01


- Release = Around 500


- Threshold = Around -30


- Ratio = 100


- Pre delay = 4.0



Gain

How much volume you feed into the compressor. Not really relevant unless everyone is too quiet, then you can turn this up a little; turning it up too much will sound EXTREMELY shitty.


Attack

How fast volume change will happen. example: setting this to 500 means that any-

thing coming in will only be dropped in volume after a half a second. for vent this should

be set as low as possible.


Release

how fast the compressor stops changing things. not really that relevant with vent, setting it around 500 is good for voice material.


Threshold

This sets the point where we actually start changing what�s coming in. Whereas 0 is the absolute loudest you can have for an input, -60 is super quiet. Average users will probably come in somewhere around -25 to -15, with the occasional few being really quiet, which is why I have this set so low.


Ratio

How much any sound below the set threshold gets compressed and/or modified in the volume department.

If you still want to hear SOME volume variation then set this lower (2-4)... the higher you set it the closer in volume everyone will be.


Pre delay

Mostly just deals with processing; with computer and digital processors they can look ahead a few milliseconds to see what needs to be dropped in volume or changed before it actually comes through the speakers. Highest is ideal.



/fl3xib3l